Fiat ECU Magneti Marelli MJD6JF.xx | MJD6F3.xx Programming Service

FIAT MJD6JF.xx | MJD6F3.xx ECU Cloning / Virginising Service (Self Coding)

This is a programming service ONLY – We are NOT supplying the ECU Unit!!

• The 'Virginizing sevice only' option above is for the virginizing of a used / secondhand ECU so it can be re-used on another vehicle – Once it has been re-programmed to an ‘As new’ (Virgin) state it will self code to your immobilizer system when it is plugged in with no further programming of keys etc necessary. Full installation instructions included. If for any reason it will not self code you can send it back with your original unit for bench programming (Data transfer) at no extra cost! Simply send us your ‘Locked’ ECU & we virginize it ready for re-use in just a few days! *IMPORTANT* Please note: To use this service it is essential that your replacement ECU has a matching part number to your original ECU!
• The 'Cloning service only' option above  is for a Cloning (Data transfer) service. If you have a faulty ECU (Electronic Control Unit) / Module on your vehicle, for example it may be water damaged or have a blown component and are looking to replace the unit you may be aware that you cannot simply remove a unit from another vehicle & install it onto yours as the unit is 'Locked' to a different vehicles electronic / immobilizer system. We have the solution! Simply send us your original (Faulty) unit & the donor (Replacement) unit & will will transfer the immobilizer data from your original to the replacement enabling the used unit to work on your vehicle with no further programming necessary. In most cases we can extract the necessary data whether your original unit is completely dead with 'No communication' with a diagnostic scanner. Once the donor unit has been programmed (Cloned) your vehicle will then start & run, the mileage display & the central locking etc will be unaffected & operate as it should.